How to prevent the leakage current transformer from burning

Aug 01, 2022|

1 Current transformer burned out

(1) The secondary lead of the current transformer will cause high voltage and cause the current transformer to burn out.

(2) If the service life of the current transformer is too long, the insulating layer will become brittle, and part of it will penetrate or be charged and discharged, resulting in overvoltage, which will cause the current transformer to become hot and burn out.

(3) The air oxidation on the surface of the aluminum bar when the current transformer is connected at one time is too heavy, the loop resistance is too large, and the current transformer is burned out due to heat.

(4) The user is overloaded for a long time, which makes the current transformer hot and burnt.


2 Problems existing in special transformer user circuit breakers and wiring

(1) Generally, 10kV vacuum pump circuit breakers and SF6 circuit breakers are equipped with current and overload maintenance, showing that the circuit breaker can properly trip when two-color short-circuit faults and overloads occur, and the overvoltage is removed by the installed active zinc oxide arrester. The current transformers for high-voltage metering of special-purpose transformers managed by our company are placed between the knife switch and the circuit breaker, so that once the current transformer has a problem, neither the circuit breaker nor the arrester can be removed, and the circuit breaker at the upper level will trip. Electricity removal faults, and subsequent expansion of the scale of power outage operations, will also cause current transformers to burn out due to the removal of faults at times.

(2) When a single-phase grounding occurs on the user side, because the circuit breaker does not trip, it is necessary to pull the contract one by one to exit the branch on the public network in order to find the connection address, and will continue to stop using the public line and expand the scale of power-off operation.

(3) The insulation layer of the arrester on the user side is brittle, which cannot effectively avoid overvoltage.


3 Take precautions

(1) The watchdog 1 circuit breaker is installed to avoid branch failures involving the power failure of a feeder, especially to ensure that the branch circuit breaker can trip reliably when the single-phase grounding of the power consumption side.

(2) Lead the metering current transformer to the back of the circuit breaker to ensure that the circuit breaker and arrester are properly positioned to remove the fault when the metering current transformer fails.

(3) Improve the high-voltage insulation layer test of the user's high-voltage metering current transformers and arresters (technical specifications do not exceed four years), detect the embrittlement level of the insulation layers of the metering current transformers and arresters as soon as possible, and replace them immediately to avoid the display of metering current. Transformer burns out to produce power outage.

(4) Clean the user's primary equipment on time to reduce flashover and avoid the reduction of the insulating layer.


Send Inquiry