Inspection and installation steps of voltage transformer
May 26, 2023| 1. Check whether the porcelain sleeve of the product has cracks, whether the edge is smooth, whether there are burrs, roughness, damage, etc., and try to see if the glue between the porcelain tube and the upper cover is firm. There should be no looseness.
2. Check the oil level of the voltage transformer. The oil level indicator should display normally without oil leakage or blockage. Generally, the oil level should meet the requirements and should not be too high or too low. If the oil level is too low, it will The insulation material of the voltage transformer will be damaged and heating will occur; if the oil level is too high, the internal pressure of the closed voltage transformer will be too large.
3. Check whether the voltage transformer has oil leakage. If oil leakage is found, the iron core needs to be lifted out. After draining the oil, the leak should be repaired. The valve on the oil tank should be able to rotate flexibly.
If everything is normal after checking the voltage transformer, what will be the installation procedure next?
The voltage transformer is basically installed directly on the concrete pier, and it is necessary to ensure the strength of the concrete pier before installation.
Sometimes the voltage transformer is also installed in a complete set of switch cabinets. In this case, only wiring is required. Be careful not to tilt it too much when moving it, and the casing must be grounded.


