Measures to prevent explosion of miniature current transformer
Jun 19, 2021| Miniature current transformer is a relatively good electrical measuring equipment, and it is precisely because it is an electrical equipment, we should pay attention to some safety knowledge when using Dasein. To prevent the explosion of the miniature current transformer, first of all, when the test value is abnormal, the cause should be found out.
When the value of the dielectric loss factor measured before and during the operation of the miniature current transformer is abnormal, it should be comprehensively analyzed and the temperature has changed significantly or the test voltage has risen from 10kv to Um/piece 3, and the increment exceeds ±0.3%. Exit the operation. When the chromatographic analysis results are abnormal, follow-up analysis should be conducted to examine the growth trend. If the data grows rapidly, attention should be paid. Eliminate the accident in the bud.
Immediately afterwards, attention should be paid to the normal operation of the bus differential protection. In order to avoid the breakdown accident at the bottom of the capacitor core of the miniature current transformer and expand the scope of the accident, attention should be paid to the correct installation direction of the primary terminals L1 and L2 and the polarity connection of the secondary winding to ensure the normal busbar differential protection. put into service.
Also pay attention to check the short-circuit current, according to the development of the power grid, pay attention to check the short-circuit current at the location of the current transformer. When it exceeds the dynamic and thermal stable current value on the nameplate of the transformer, arrange and replace it in time. It should be integrated board to carry out online monitoring and infrared temperature measurement.


