What are the warning signs when the current transformer is overloaded?

Jul 11, 2025|

1. Overheating
Rising temperature: The current transformer may overheat, smoke or even flow.
Cause: It may be due to poor contact of the primary wiring, severe oxidation of the secondary wiring board surface, short circuit or insulation of the current transformer turns.
2. Open circuit on the secondary side
No indication on the ammeter: The ammeter suddenly shows no indication, and the sound of the current transformer increases significantly.
Ozone smell and discharge sound: The smell of ozone can be smelled, and a slight discharge sound can be heard near the open circuit.
Danger:
High voltage is generated, posing a threat to the safety of equipment and operators.
Increased core loss, severe heating and equipment burning.
Magnetic saturation in the core will increase the error of the current transformer.
3. Internal sound or discharge phenomenon
Surface discharge: If the surface of the current transformer is discharged, it may cause the surface of the transformer to become dirty, thereby reducing the insulation performance.
Internal discharge sound: The insulation inside the current transformer is reduced, resulting in the primary winding to the secondary winding and the core disconnecting and discharging.
4. Abnormal internal sound
Loose core: The fastening screws of the current transformer core are loose, the core is loose, the silicon steel vibration increases, and abnormal noise that does not change with the load is emitted.
Poor silicon steel assembly process: Some cores have a certain buzzing sound when no-load or off-load due to poor silicon steel assembly process.
Secondary side open circuit: Magnetic saturation and non-sinusoidal magnetic flux cause the silicon steel sheet to oscillate, the oscillation is uneven, and a large noise is emitted.
Severe overload: The current transformer is severely overloaded, which increases the vibration of the core.
5. Oil-filled current transformer leaks oil
Severe oil leakage: Oil-filled current transformers may have severe oil leakage.
6. Hardware warning signal
Overload signal: Through the current sensor and comparator, when the current exceeds the set maximum current value, the comparator will output a high-level signal, indicating that the current is overloaded.
Warning device: The comparator output signal can be connected to a warning light or other device to provide a warning or control other operations.

Hall Effect Current Sensor For Power Electronics Testing And Measurement LO-HAOL-EK

Send Inquiry