Choice of Current Transformer and Zero Sequence Current Transformer
Aug 26, 2022| Current transformers and zero-sequence current transformers are all monitoring of the common fault current of the route. Generally, there is only one transformer core and secondary winding. When applied, the three-core cable will cross the core window of the transformer, and the second transmission line will be connected to the special-purpose automotive relay according to the transmission line, and then the output of the automotive relay will be connected to the data signal equipment or alarm. Under normal circumstances, the three-phase voltage fundamentals in the primary power circuit are balanced and the flux generated is also close to zero. There is no induced electromotive force in the secondary winding of the transformer. When the common fault of single-phase grounding occurs in the primary and intermediate power supply circuit, it will cause unbalanced current (ie zero sequence current) in the primary and intermediate power circuit, and will cause a small current in the secondary winding. Car relay posture, data signal appears. The current amount (mA level) in the operation of the automotive relay is not large, which is called the secondary coil current amount or the sensitivity of the zero-sequence current transformer (also expressed by the smaller posture current amount), which is the key Posture indicator. In the 10kV feeder switchgear, the current transformers located inside the power switch are generally divided into two-phase or three-phase.
The current transformer is composed of primary and secondary windings (L1, L2) and secondary windings, transformer core and silica gel. Current Transformer The current transformer is a small current, which transforms the primary and intermediate machinery and equipment of large current into the secondary coil machinery and equipment. Its principle is equivalent to a transformer with small characteristic impedance. The primary and secondary windings are connected in series with the primary and secondary power supply circuits, and the secondary windings are connected with the load. The proportion of the current transformer is generally X / 5A or X / 1A (X is not lower than the large long-term load current that will appear in the machinery and equipment), so the secondary coil current of the current transformer does not exceed 5A or 1A. In power stations and substations, if the high-voltage substation equipment eliminates the main control room, in order to increase the allowable load of the secondary coil of the converter, please reduce the wire socket of the connecting cable and improve the accuracy, and select the rated secondary coil. Voltage. It is a 1A current transformer. Correspondingly, the microcomputer protection device should also be used for products with an AC voltage of 1A.
In the distribution station, the current transformer is used in three power circuits: microcomputer protection, accurate measurement and measurement verification, and the three power circuits have different requirements for the precision of the current transformer. According to the accuracy, the winding resistance of the current transformer can be divided into 10P10 (maintenance), 0.5 (accurate measurement) and 0.2S (measurement verification). The winding used for accurate measurement and metrological verification focuses on precision, and the winding used for maintenance focuses on volume, so as to prevent the saturation state of the transformer core from harming the specific proportion. There are three common types of wiring for the secondary winding of the current transformer: complete star connection, incomplete star connection and delta connection.


