Current transformer troubleshooting
Oct 16, 2023| (1) To effectively solve the problems existing in the transformer, the first thing to change is the environment. It cannot be placed in a humid environment, and then the transformer is replaced. The selection of the transformer needs to be able to make it compatible with the load. It is consistent, and at the same time, those who are wrongly connected must be corrected on the line.
(2) When troubleshooting, it is necessary to cut off the power supply system in advance, check the circuits, and eliminate the faults in each circuit bit by bit. In the inspection of circuit faults, safety issues need to be paid attention to, and the voltage of the primary load current must be reduced to a minimum, so that the voltage in the secondary circuit can also be reduced. When performing troubleshooting, workers need to wear insulating gloves and tools with good insulation, and they also need to operate on insulating pads. When correcting the route, it is also necessary to compare the route drawing to the construction, so that the position of each route can be accurately found. Since the secondary open circuit in the current transformer is very secretive and difficult to detect, there are no obvious signs of the transformer during inspection, but it will always be in an open circuit state. Therefore, you need to watch and listen very carefully when inspecting it, and you cannot easily let go of various small details.
(3) If heating occurs in the crimping area of the wiring, some abnormalities will occur during operation. The correct treatment method at this time is to polish it first to increase its contact area and allow it to The contact can be maintained in good condition, and then conductive paste and springs are used for compression control, so that it can melt and shrink. For manufacturers, the length of the wiring board needs to be appropriately increased, and screws can be used to stabilize it. , so that the contact surface can be made larger and stronger, reducing the occurrence of heating failures.


