What is the difference between current transformer and voltage transformer?

Nov 03, 2023|

1. Structural differences:

The primary winding of the current transformer is wound with thick wire, usually with only one or a few turns, and is connected in series with the load of the current being measured; the voltage transformer is a step-down transformer, with many primary winding turns, connected in parallel with the high-voltage power grid being measured. ; The secondary winding has a small number of turns and is connected to the voltage coil of the voltmeter or power meter.
2. Differences in working principles:

The normal working conditions of the two devices are very different, as shown in the following:

1) The secondary current transformer can be short-circuited, but must not be open-circuited; the secondary voltage transformer can be open-circuited, but must not be short-circuited.

2) Compared with the load on the secondary side, the primary internal impedance of the voltage transformer is so small that it can be ignored, and the voltage transformer can be considered to be a voltage source; while the primary internal resistance of the current transformer is very large, so that it can be considered It is a current source with infinite internal resistance.

3) The magnetic flux density of the voltage transformer is close to the saturation value when it is working normally, and the magnetic flux density decreases when it fails; the magnetic flux density is very low when the current transformer is working normally, but when it is short-circuited, the primary side short-circuit current becomes very large, causing the magnetic flux density to become very large. The flux density increases greatly, sometimes even far exceeding the saturation value.
3. Functional differences:

The role of current transformer In order to ensure the safe and economical operation of the power system, the operation of the power equipment must be monitored and measured. However, general measurement and protection devices cannot be directly connected to primary high-voltage equipment. Instead, the large current of the primary system needs to be proportionally converted into a small current for use by measuring instruments and protection devices.

The function of the voltage transformer is to convert high voltage into a standard secondary voltage of 100V or lower in a proportional relationship for use in protection, measurement, and instrumentation devices.

The difference between the two is that one measures current and the other measures voltage. The current transformer is connected in series in the circuit, the primary winding has fewer turns than the secondary winding, and the secondary winding cannot be open-circuited; the voltage transformer is connected in parallel in the circuit, the primary winding has more turns than the secondary winding, and the secondary winding cannot be short-circuited.

Send Inquiry