What should be paid attention to when Miniature Current Transformer is connected in series

Jan 14, 2022|

The wiring of the Miniature Current Transformer should follow the series principle: the primary winding should be connected in series with the circuit under test, and the secondary winding should be connected in series with all instrument loads. Choose the appropriate change according to the current to be measured, otherwise the error will increase. At the same time, it is necessary for the secondary side to be grounded to avoid damage to the insulation when pressing the primary side into the secondary low voltage side, and then cause personal and equipment accidents.


The secondary side is not allowed to be disconnected. When the Miniature Current Transformer works normally, the secondary side is approximately short-circuited. If it is suddenly turned on, the excitation electromotive force suddenly changes from a small value to a large value, and the magnetic flux in the iron core presents a very full flat top. Therefore, when the magnetic flux passes through zero, a high peak wave will occur in the secondary winding, and its value can reach thousands of volts or even tens of volts, which has a great impact on the safety of crisis management personnel and the insulation function of the instrument.


In addition, an open circuit on the secondary side can generate hundreds of volts at E2, which can cause an electric shock if touched. Therefore, the secondary side of the Miniature Current Transformer is provided with a short circuit switch to avoid primary side disconnection. During use, once the secondary side is disconnected, the circuit load should be removed immediately and then stopped. Once everything is processed it can be reused.


When the protective Miniature Current Transformer of the equipment is used, the protection of the protective equipment should be withdrawn as much as possible. area to be set. If there are two sets of current transformers and the positions are allowed, they should be placed on both sides of the circuit breaker so that the circuit breaker is within the scope of protection.


In order to reduce the harm of the internal fault of the generator, the output side of the stator winding of the generator should be used to automatically adjust the current transformer of the excitation equipment. To facilitate analysis and find internal faults before incorporating the generator into the system, the Miniature Current Transformer used for the measuring instrument should be installed at the neutral point of the generator.


Send Inquiry