Common Errors in Current Transformer Compensation

Jan 26, 2026|

I. Errors in Compensation Calculation

Turns Compensation: Calculating a -0.5% ratio difference as -1% may lead to excessive secondary current, increasing the error.

Capacitor Compensation: Using a 50Ω capacitor with a 10Ω secondary impedance will reduce the effectiveness of phase difference compensation.

II. Errors in Operation Procedures

Secondary Side Open Circuit: Failure to ground during compensation or short-circuiting when replacing the meter may cause high-voltage hazards.

Wiring Errors: Reversing the polarity of P1-S1 will worsen both the ratio difference and phase difference.

III. Errors in Method Selection

Protective Transformer Compensation: Using turns compensation for 5P/10P transformers may lower the accuracy limit factor.

Magnetic Shaft Compensation: Relying solely on this may result in unbalanced ratio difference and phase difference compensation.

IV. Neglecting Process and Environmental Factors

Core Assembly: Insufficient precision will increase leakage flux.

Environmental Interference: Changes in temperature and humidity may cause error fluctuations.

How to Properly Install Split Core Current Transformers?

Send Inquiry