Explosion prevention of current transformers
Aug 22, 2022| In order to prevent the explosion of the miniature current transformer, it is first necessary to find out the reason for the abnormal test value. When the dielectric loss coefficient TG measured before and after operation is abnormal, the obvious change of Tgδ and temperature should be comprehensively analyzed or the test voltage is increased from 10 kV to Um/root 3, and the increment of TGδ should be greater than 0.3%. When the chromatographic analysis results are abnormal, it is necessary to carry out follow-up analysis and investigate its increasing trend. Care should be taken if the data is increasing rapidly. Nip accidents in the bud.
In order to prevent the explosion of the miniature current transformer, attention should be paid to the normal input of the busbar differential protection. In order to avoid the breakdown accident at the bottom of the capacitor core of the micro-current transformer and expand the scope of influence of the accident, attention should be paid to the installation direction of the main wiring L1, the installation direction of L2 and the pole connection method of the secondary winding to ensure the normal operation of the bus differential protection. .
In order to prevent the explosion of the miniature current transformer, attention should also be paid to the checksum calculation of the short-circuit current. According to the development of the power grid, it should be noted that the short-circuit current should be checked and calculated at the position of the current transformer. When the dynamic thermal stability current value above the transformer nameplate is exceeded, it must be arranged and replaced in time.
In order to prevent the explosion of the miniature current transformer, online monitoring and infrared temperature measurement should be carried out. At present, the online monitoring items of miniature current transformers mainly include measuring the capacitance and dielectric loss factor TGδ of the main insulation, and measuring the insulation resistance and dielectric loss factor TGδ of the final shielding insulation. The test results show that the method is effective for the detection of insulation defects. For infrared thermometry, some units are already doing it. The existing test results show that the detection of the looseness of the internal joints of the current transformer is effective, but experience is still needed.


