Fault Analysis of Primary Winding of Current Transformer

Aug 05, 2022|

Internal fault of current transformer product

To analyze the reasons for the error of the current transformer, first of all, it is necessary to fully consider whether the current transformer itself is faulty. After the original current transformer, if the insulation is damaged during transportation or installation, part of the potential will communicate with the oil conservator, and the current direction of the current transformer will also change accordingly. The primary current is reversed according to the oil conservator of the current transformer, and some of the currents are not based on the secondary winding of the oil tank under the current transformer, so that the excitation of the primary current of the current transformer to the secondary current is changed. Causes a relatively serious deviation of the error. When this type of fault occurs, people conduct tests on the current transformer on site, and it is found that the error generated by each secondary winding does not meet the requirements of the equipment specifications, and the error has a large error problem. According to the scientific statistics of the researchers, such conditions are relatively rare, so it is easy to identify the cause of the fault when diagnosing the fault.


Primary bus connection failure during field test

When the field test of the current transformer is carried out, the busbar is connected to the terminal of the current transformer, the insulation distance between the side busbar and the oil conservator is small, or the two are overlapped, or even the bolts in the side busbar and the oil conservator are connected. Lap together will cause the primary current to separate when it is connected to the oil conservator. This situation will immediately change the excitation of the primary current to the secondary current, and the resulting error will also be slightly larger. For example, a current transformer product produced by a certain manufacturer, the controller can accurately measure the frequency range: from 0.7Hz to 350MHz, the current range from: 20mA to 500kA random current data signal, including accurate measurement of transient data signal, pulse current, single pulse , sinusoidal, radio frequency and various complex circuit data signals, and ensure that the detection accuracy is not less than 1%. After receiving the product, the user first conducted a test on the current transformer, and found that the side busbar and the upper bolt of the oil conservator were overlapped, and the current error was caused by this reason. Then, under the specific guidance of the current transformer product manufacturer, the customer adjusted the lap between the side busbar and the bolt. After another experiment, the error of the current transformer reached the standard. After guessing, the reason for the large error of the customer should be the problem of the current transformer in the transportation environment.


Send Inquiry