Measurement of Full Point of Current Transformer
Feb 06, 2023| In order to accurately check whether the excessive current of the current transformer will be full and affect the correctness of the maintenance action, the direct and effective way is to carry the actual load on the secondary side and pass in the current from the primary side. In addition, the transformer factory can also measure the full point of the miniature current transformer through the volt-ampere characteristic experiment.
The current transformer is full because the core magnetic flux density is too large to calculate the full current of the miniature current transformer. Open the circuit on the primary side, pass the current from the secondary side, and measure the voltage drop on the secondary side winding. Because the original side of the miniature current transformer is open circuit, there is no demagnetization effect of the original side current, and the iron core is easy to be full under the action of a small current. Therefore, the volt-ampere characteristic experiment does not need to add a large current.
In the application process, to prevent the current transformer from burning out, first install a circuit breaker to prevent branch faults from involving the entire line from blackout, especially to ensure that the branch circuit breaker can reliably trip. Then connect the current transformer to the back of the circuit breaker to ensure that the circuit breaker and arrester operate correctly when the transformer fails to eliminate the fault.
Secondly, strengthen the high-voltage insulation test of the user's current transformer and arrester, detect the aging degree of the insulation of the transformer and arrester early, and replace it in time to prevent the occurrence of power outages caused by the burnout of the transformer. It is necessary to clean the user's equipment regularly to reduce pollution and prevent insulation degradation.
In addition, it is necessary to carefully check whether the secondary circuit is open or not, and whether the resistance of the touch is too large. The most important thing is that it cannot be overloaded. In addition, it is necessary to protect and maintain the current transformer. If the insulation is found to be aging, it must be replaced in time, and it must be cleaned regularly to reduce pollution. Only in this way can the current transformer be used safer and have a longer service life.


