DC Residual Current Transformer
HALL EFFECT CURRENT SENSOR
- Product Introduction
Wuxi Liou Electronics Co.,Ltd is one of the leading manufacturers and suppliers of dc residual current transformer in China. Our factory offer high quality customized products made in China with low price. Welcome to contact us for quotation.
A new type of current sensor based on the principle of magnetic modulation is developed, which can measure the small DC current signal in mA level under the condition of electrical isolation.
Electrical parameters
P/N | LO-DS010LT | LO-DS020LT | LO-DS050LT | LO-DS100LT | ||
IPN | Rated input current | 10 | 20 | 50 | 100 | mA |
IP | Measuring current range | 0~±12 | 0~±240 | 0~±60 | 0~±120 | mA |
VOUT | Rated output voltage | 5±1% | V | |||
VC | Power voltage | ±12~±15(±5%) | V | |||
IC | Current loss | VC=±15V <30 | mA | |||
Vd | Hi-pot test | P-S:AC3KV/50Hz/60S | ||||
εL | Linearity | <±1 | %FS | |||
V0 | Zero point offset voltage | TA =25℃ ±50 | mV | |||
VOT | Temperature drift of malfunction | IP=0 TA = -10~+70℃ <±1 | mV/℃ | |||
f | Frequency band | DC | ||||
TA | Operation temperature | -10~+70 | ℃ | |||
TS | Storage temperature | -25~+85 | ℃ | |||
RL | Load resistor | ≥10K | Ω | |||
Dimensions(mm)
![7NM6L_EC[_]1MTM2JH})G(B](/Content/uploads/2021422415/20210531151157d521d39e7adf4afea232ff71a9fd959a.jpg)
Instructions
1、The incorrect wiring connection may cause sensor damage. When the sensor is electrified, the measured current passes through the arrow direction of the sensor, the in-phase voltage can be measured at the output end.
2、The output amplitude of the sensor can be adjusted appropriately according to the customers’ requirements.
3、Sensors with different rated input currents and output voltages can be customized according to user requirements.
Hot Tags: dc residual current transformer, China, manufacturers, customized, quotation, low price, made in China, Closed Loop Hall Effect High Current Sensor, Closed Loop Hall Effect Sensors, Hall Effect Sensor
You Might Also Like












