Analysis of Factors of Current Error in Current Transformer

Jan 20, 2023|

(1) Improper selection of the electric energy meter During the operation of the electric energy meter, the load current causes the error of the electric energy meter. Among them, due to the large amplitude of the coincident current, or because the current is too small, the result is that the change of the current standard transformer does not coincide with the actual electric energy measurement, resulting in measurement errors. In the actual use of the three-phase electric energy meter, the current measurement is not stable due to the uneven load of the three-phase four-wire during the measurement. In the three-phase watt-hour meter, the neutral point is charged, because lb=In-la-Ic in the circuit, the result is that the power consumption in Ib in the formula is not calculated into the formula, causing measurement errors.


(2) In the measurement of the voltage standard transformer, the load current will produce a significant voltage drop when passing through the wire. Such a voltage drop will cause an error in the test on the electric energy meter, which is not consistent with the error on the connecting wire, resulting in current measurement error.


(3) The error of the electric energy meter itself. There are corresponding industry standards for the manufacture of electric energy meters. However, in the process of manufacturing design, some manufacturers use rare earth magnets to design and manufacture electric energy meters. As a result, the quality of the electric energy meters produced is poor and the durability is poor. . Although these products passed the preliminary inspection, due to the poor magnetic effect retention during use, the test results became more and more unstable, and the error of the electric energy test became larger and larger. Such errors are caused by design errors, which can be revised by strengthening the standards and design of electric energy meters.


(4) The error generated by the current standard transformer. In the application process of the current transformer, when the current passes through the primary winding, an induced electromotive force is generated. In the process of passing through the circuit transformer, the magnetism may be consumed to generate magnetic flux. During this sensing process, the consumption of excitation ampere-turns leads to errors in current metering.


The error of the current transformer is mainly related to the ratio difference and angle difference. In the impact on the ratio difference and angle difference, it is related to the charge angle Φ; the iron core resistance angle α is related to the external load impedance zb. When studying the current of the current transformer, it can be seen from the current characteristic curve that the error characteristic curve should be controlled between 25% and 100%. In the curve, the primary current is between 30% and 60% of the rated current, so that the current transformer can reach the state, and the influence of the error is small. At present, electronic watches are widely used, and the value of the secondary load generated is far lower than that of mechanical watches, and is smaller than 25% of the rated value. Such a difference will lead to out-of-tolerance situations.


Send Inquiry