-

2021-8-16Features and use occasions of Split Core Current Transformers
As my country and various enterprises pay attention to energy management, government buildings, corporate factories, and office buildings that have been built everywhere have begun to install and inst -

2021-8-15Opening and closing current transformer installation requirements
1. Construct according to the drawings, the wiring is correct, the numbered labels at both ends of the wires should be clear, and the label range meets the specified requirements. 2. The current and v -

2021-8-14What are the reasons for the burning of the Electrical Current Transformer
1. Install circuit breakers to prevent branch faults from power outages of the entire line, especially to ensure that the branch circuit breakers can reliably trip. 2. Connect the Electrical Current T -

2021-8-13Measures to determine the saturation point of Multi Core Current Transformer
The direct experimental method is to bring a practical load on the secondary side, pass in current from the primary side, and observe the secondary current to find the saturation point of the Multi Co -

2021-8-12Fixed method of Split Core Current Transformers
1. Fix with positioning screws: the fixing screws are locked by two positioning screws with a 90° gap. In the traditional fixing method, the front end of the screw contacts the shaft, which may cause -

2021-8-11Equipment required to verify Electrical Current Transformer
1. Transformer calibrator: Measure the error between the standard transformer and the tested transformer, and display the working current. 2. Standard Electrical Current Transformer: It is used as a s -

2021-8-10Patrol inspection run by Electrical Current Transformer
(1) Check the porcelain part should be clean, no damage, no cracks, no traces of discharge. (2) Check that the oil level should be normal, the oil color should be transparent and not blackened, and th -

2021-8-09Allowed operation mode of Electrical Current Transformer
(1) Allowable operating capacity. The Electrical Current Transformer should operate within the rated capacity specified on the nameplate. If the operation exceeds the rated capacity of the nameplate, -

2021-8-07How the Multi Core Current Transformer works
The basic principle of zero sequence current protection is based on Kirchhoff's current law: the algebraic sum of the complex current flowing into any node in the circuit is equal to zero. When th -

2021-8-06Wiring precautions for Power Current Transformer
1. Generally speaking, the connection of the Power Current Transformer is connected according to the minus polarity, so the polarity connection must be correct. Once the connection is wrong, the measu -

2021-8-05What is the wiring principle of Power Current Transformer
1, No open circuit is allowed. The secondary open circuit can easily lead to safety accidents, because the secondary open circuit will cause the iron core to overheat and induce high voltage. 2. There -

2021-8-04What is the impact of Power Current Transformer being too small
1. After repeated testing and analysis by the power supply bureau, the load is too large, and the power current transformer ratio is too small to ensure the authenticity of the measurement and the acc


