-

2021-8-03Power Current Transformer installation precautions
1. The polarity of the Power Current Transformer should not be reversed, and the phase sequence and phase distinction should meet the design and regulatory requirements. For the transformer wiring for -

2021-8-02How to install Power Current Transformer
(1) Install the Power Current Transformer on a metal frame (such as a busbar frame). (2) Where the bus bar passes through the wall or floor, the Power Current Transformer is directly fixed to the wall -

2021-8-01What are the common faults of Power Current Transformer
1. Overheating occurred. Power Current Transformer has overheating, smoking, glue flow, etc., which may be caused by poor primary side wiring, severe oxidation on the surface of the secondary side wir -

2021-7-31What are the precautions for using Power Current Transformer
(1) First of all, Power Current Transformer is marked by minus polarity. If the polarity is connected incorrectly, it will not only affect the current measurement value, but also cause a short circuit -

2021-7-30Precautions for using Split Core Current Transformers
1. Before use, you need to carefully check whether the appearance is deformed and keep away from the strong magnetic field, otherwise it will affect the accuracy of the test; 2. Before using Split Cor -

2021-7-29Split Core Current Transformers installation requirements
1. Construct according to the drawing, the wiring is correct, the numbering labels at both ends of the wire should be clear, and the label range should meet the specified requirements. 2. The current -

2021-7-28How to extend the life of Split Core Current Transformers
One, the quality of purchase should be good The high-quality Split Core Current Transformers have strong reliability, good stability, and quality assurance, which can get twice the result with half th -

2021-7-27Reasons why the Electrical Current Transformer cannot open the circuit
We know that the Electrical Current Transformer transforms a large current into a small current, and because the Electrical Current Transformer is similar to a step-up transformer, we are opposite acc -

2021-7-26Design points of Electrical Current Transformer
The Electrical Current Transformer is composed of a closed core and windings. Its primary winding has a few turns, which is stringed in the line of the current that needs to be measured. Therefore, it -

2021-7-24Causes and solutions for possible failures of Electrical Current Transformer
1. Reasons for the failure of Electrical Current Transformer Structure Generally, when the voltage is higher than 32kV, the material used to manufacture the internal structure of the transformer is us -

2021-7-23What should I do if the Electrical Current Transformer gets damp?
(1) Oven drying method. The specific operating procedures of the oven drying method are as follows: 1 First remove the secondary winding from the Electrical Current Transformer, and mark the secondary -

2021-7-22Installation rules of Electrical Current Transformer
1. The polarity of the Electrical Current Transformer cannot be reversed. The phase sequence and phase should meet the design and adjustment requirements. For the connection of the differential protec


