-

2021-10-04Troubleshooting of the secondary open circuit of Electrical Current Transformer
(1) The indication of the loop instrument is abnormal, which is generally reduced or zero. The open circuit of the current loop used to measure the meter will cause the indication of the three-phase a -

2021-10-03Causes of Overheating of Secondary Terminals of Electrical Current Transformer
Causes of overheating of the secondary terminals of the Electrical Current Transformer: When the short tabs of the secondary terminals of the Electrical Current Transformer that are not connected to t -

2021-10-02How to deal with the secondary open circuit fault of Electrical Current Trans...
1. If the Electrical Current Transformer is found to be open for the second time, you should first distinguish which group of current circuits the fault belongs to, the difference of the open circuit, -

2021-10-01What checks need to be done before the current transformer error experiment?
1. Accurately compare the measured transformer with the standard transformer, the secondary current difference of the two transformers is 1. Accuracy check: the transformer error test generally uses t -

2021-9-30Causes of Electrical Current Transformer saturation problems
The saturation of the Electrical Current Transformer can be divided into two categories: one is the saturation caused by the large-capacity short-circuit steady-state symmetrical current (steady-state -

2021-9-29Iron core structure of Electrical Current Transformer
The commonly used iron core forms of Electrical Current Transformer are laminated iron core, rolled iron core (also called ring iron core), open iron core, etc. 1. Laminated iron core. A cold-rolled s -

2021-9-28Electrical Current Transformer explosion prevention measures
(1) Check whether the lead connector in the primary terminal of the transformer is in good contact The lead joints of the primary terminals of the Electrical Current Transformer must be in good contac -

2021-9-27Precautions for Residual Current Sensor wiring
1. Be sure to distinguish phase wire, n wire and pe wire before wiring, otherwise problems will occur, resulting in inaccurate measurement data and false alarms. 2. The phase line and the N line must -

2021-9-26Installation location of Residual Current Sensor
The residual working current transformer should be installed in a place that is convenient for maintenance, as far as possible away from the strong magnetic field. The installation company of the tran -

2021-9-25Installation requirements for Split Core Current Transformers
1. According to the engineering drawings, the wiring is appropriate, the line number identification on both sides should be clear, and the identification category meets the requirements. 2. The curren -

2021-9-24Precautions when using the Hall sensor
1. In order to better obtain good dynamic performance and sensitivity, be sure to pay attention to the coupling of the primary side electromagnetic coil and the secondary side electromagnetic coil, an -

2021-9-23The reason why the secondary side is not allowed to open when the Electrical ...
⒈Electrical Current Transformer Once the measured current, the magnetic potential I1N1 causes the magnetic flux Φ1 in the transformer core ⒉Electrical Current Transformer secondary detection instrumen


