-

2021-5-29What are the factors of current transformer accuracy
The magnitude of the secondary load impedance of the current transformer has a great influence on the accuracy of the transformer. This is because the secondary load impedance of the current transform -

2021-5-28Precautions for the use of open-close current transformers
1. Be sure to check whether the appearance is deformed before application, otherwise the detection precision will be compromised. 2. Be sure to check whether the inner hole of the transformer core is -

2021-5-27Can the current transformer be short-circuited to ground when energized
For high-voltage current transformers, it must be grounded. But for low-voltage current transformers, the general practice is to ground the device. Why can't the secondary side of the current tran -

2021-5-26What are the differences between current transformer and zero sequence curren...
1. The application method of current transformer and zero-sequence current transformer is different. The zero-sequence current transformer is used to check the zero-sequence current. Generally, all th -

2021-5-25Installation requirements for Split Core Current Transformers
1. According to the engineering drawings, the wiring is appropriate, the line number identification on both sides should be clear, and the identification category meets the requirements. 2. The curren -

2021-5-24How to confirm the saturation of current transformer
In order to study the working characteristics of the current transformer and determine whether it will saturate and affect the correctness of the protection operation when it protects against external -

2021-5-22Corresponding solutions caused by current transformer faults
1. There is a solution to abnormal noise or over-temperature of the iron core. In the whole process of current transformer operation, if there are problems such as open circuit or overload of the seco -

2021-5-21Causes and main aspects of transformer failure
(1) In the AC circuit loop, if the structure of the experimental wiring terminal in the loop is defective, and the quality of the terminal cannot be guaranteed, then the voltage transformer is likely -

2021-5-20The reason why the secondary winding of the Electrical Current Transformer ca...
When the Electrical Current Transformer is running, the load is connected to the secondary side of the instrument or relay current coil, etc., and the impedance is very small, basically in a short-cir -

2021-5-19Installation rules of Electrical Current Transformer
1. The polarity of the Electrical Current Transformer cannot be reversed. The phase sequence and phase should meet the design and adjustment requirements. For the transformer connection of the differe -

2021-5-18Equipment required to verify Power Current Transformer
1. Transformer calibrator: measure the error between the standard transformer and the tested transformer, and display the working current. 2. Standard Power Current Transformer: It is used as a standa -

2021-5-17What is the impact of Power Current Transformer being too small
1. After repeated tests and analysis by the power supply bureau, the load is too large, and the Power Current Transformer ratio is too small to guarantee the authenticity of the measurement and the ac


