-

2023-10-02Detection and treatment measures for common faults of current transformers
1. What to do if there is abnormal sound or the iron core is overheated. During the operation of the current transformer, if problems such as an open circuit or overload in the secondary circuit occur -

2023-9-29Saturation point of current transformer
Under normal circumstances, the core magnetic flux in the current transformer is in an unsaturated state. At this time, the load impedance and excitation current are small, but the value of the excita -

2023-9-27Why is the secondary side of the current transformer only allowed to be groun...
1. Because the grounding grid of a substation is not the actual equipotential surface, potential differences will appear at different points. When a large ground current is injected into the grid, the -

2023-9-25Checking and handling method for open-circuit and short-circuit faults on the...
Since only a small impedance is allowed in the secondary circuit of the current transformer, it is close to a short-circuit state under normal working conditions, and the sound is extremely small, whi -

2023-9-22Operation and maintenance of current transformer and voltage transformer
The transformer has part of the function of a transformer, and has the function of converting the high voltage and high current of the primary circuit into the low voltage and small current of the sec -

2023-9-20Preventive Measures for Current Transformer Open Circuit
It is clearly stipulated in the electrical safety work regulations that the secondary line side of the current transformer must be reliably grounded. The purpose is to prevent the high voltage of the -

2023-9-18The difference between zero sequence current transformer and ordinary current...
The common characteristics of zero-sequence current transformers and ordinary current transformers: both zero-sequence current transformers and ordinary current transformers work according to the prin -

2023-9-15Demagnetization method of current transformer
After the polarity of the current transformer is checked by the DC method, or when the power supply is cut off under the AC current and the secondary winding is accidentally opened, the iron core may -

2023-9-13The composition and working characteristics of current transformer
1. The number of primary turns is small and the number of secondary turns is large. For current transformers used in power systems, the primary winding is usually the incoming and outgoing wires of th -

2023-9-11The difference between current transformers
1. Differences in form From a formal point of view, current transformers are mainly divided into two categories: plug-in current transformers and iron core current transformers. Plug-in current transf -

2023-9-08How are current transformers installed and regulated?
1. The metal frame on which the current transformer is installed (such as the busbar frame in the distribution cabinet) must be solid, and the exposed metal part of the transformer shell must be relia -

2023-9-06Why is a current transformer needed in a high voltage cabinet
1. Reduce the cost of measurement and protection systems: In high-voltage systems, current transformers convert large currents into small current signals, allowing the use of smaller-sized, low-cost m


