-

2025-7-11What are the warning signs when the current transformer is overloaded?
1. Overheating Rising temperature: The current transformer may overheat, smoke or even flow. Cause: It may be due to poor contact of the primary wiring, severe oxidation of the secondary wiring board -

2025-7-09What are the maintenance points of current transformers?
1. Regular inspection Appearance inspection: Regularly check the appearance of the current transformer to ensure that there are no cracks, deformation, corrosion, etc. on its surface. Wiring inspectio -

2025-7-07What should I do if the current transformer is damp?
1. Drying treatment Vacuum drying method: Place the damp current transformer in a vacuum drying device and remove the internal moisture by vacuuming and heating. This method can effectively remove moi -

2025-7-04How to properly maintain the current transformer?
1. Regular inspection Appearance inspection: Regularly check the appearance of the current transformer to ensure that there are no cracks, deformation, corrosion, etc. on its surface. Wiring inspectio -

2025-7-02How to correctly install a universal current transformer?
1. Choose a suitable transformer When choosing a current transformer, you need to choose it according to the actual needs and the parameters of the measured object. Factors to consider include: Measur -

2025-6-27What should I do if the shell of the zero-sequence current transformer is dam...
1. Replace in time: The damaged shell may cause the internal components to be affected by the external environment, so the shell should be replaced in time. 2. Ensure insulation performance: The new s -

2025-6-25How to ensure the long-term stable operation of the zero-sequence current tra...
1. Correct installation Installation location: The zero-sequence current transformer should be installed on the bottom plate of the switch cabinet and fixed with a reliable bracket. Ensure that the in -

2025-6-23How to install a zero-sequence current transformer?
1. Select the installation location Installation location: The zero-sequence current transformer is usually installed at the neutral point of the power system to detect the zero-sequence current in th -

2025-6-20Common faults and solutions of Hall effect sensors
1. Abnormal output signal: Fault phenomenon: The output signal of the sensor is unstable or inaccurate. Solution: Check whether the power supply voltage of the sensor is stable, check whether the wiri -

2025-6-18How to check the insulation damage of the current transformer?
1. Appearance inspection: Observe whether the shell, insulation, coil, etc. of the current transformer have signs of aging, electric shock, burning, etc. 2. Insulation resistance test: Use a 500V mego -

2025-6-16What are the common faults of current transformers?
1. Insulation damage Fault phenomenon: Insulation damage may cause the current transformer to leak or even short-circuit. Solution: Check the insulation resistance regularly to ensure that it is withi -

2025-6-13How often should the current transformer be checked after grounding?
Specific inspection contents 1. Grounding wire inspection: Check whether the grounding wire is corroded, broken, etc., and whether the grounding terminal is loose. 2. Insulation inspection: Regularly


